This simple to use gauge is ideal for evaluating the
resistance of a coating to impact ( elongation, cracking
or peeling) .
There are two test methods: either a weight with a
....

Gloss is measured by directing a
constant power light beam at an angle
to the test surface and monitoring the
reflected light. Different surfaces require
different reflective....

Rugged & repeatable hand held gauges designed to non destructively measure the thickness of metal substrates whilst ignoring the thickness of up to 2mm ( 80mils) of an applied....

Elcometer has a wide range of transducers available for use with the Elcometer 205, 206, 206DL, 208 & 208DL Ultrasonic Thickness Gauges. When selecting a transducer, it is....

Pre-calibrated for ease of use, the Elcometer 204 Steel Ultrasonic Thickness Gauge provides a fast, accurate measurement of the thickness of steel.

Each gauge is supplied with....

The Elcometer 148 is a simple, easy-to-use instrument for measuring both pH and temperature, using a single sensor.

pH is the measure of acidity of a liquid. As pH is....

The Elcometer 138/ 2 Surface Contamination Kit provides the means for testing invisible surface contaminants:

pH
chloride ions
iron
salts

KIT CONTENTS
E135----A ....

Soluble salts on a surface are absorbed into a special filter paper soaked with distilled water. The Elcometer 130 measures the conductivity of the wet paper, calculates the salt....

Product Description

The Elcometer 135A Bresle Sampler is a self-adhesive rubber film patch with a sealed compartment for sampling of soluble impurities from steel surfaces with....

If the chloride levels in the wash water are too high, this will promote premature corrosion, shortening the life of both steel and concrete structures.

Used to monitor....

Chloride salts left on the surface before the first coat is applied can result in the coating system being forced off the surface by corrosion or blistering before the full life....

Incorporating a flat sensor, the Elcometer 138 Conductivity Meter can measure the conductivity of a solution from a single drop of a sample.

Users can either place a sample on....

It is essential that the level of contaminants on a surface is measured prior to application of the coating to ensure the quality of the coating and that its optimum lifetime is....

Chlorides deposited on a surface by contaminated abrasives during blasting can cause a coating to fail prematurely.

Contamination can build up, particularly if the blast media....

The Elcometer 142 Dust Tape Test kit allows assessment of the quantity and size of dust particles on surfaces prepared for painting.

Dust on blast cleaned surfaces can reduce....

The Elcometer Fitzâ € ™ s Atlas of Coating Defects ( EFA) takes the reader through a comprehensive range of problems and discusses each in detail.

EFA provides the User with a....

The aim of this publication is to illustrate the range of defects that may be encountered in high pressure steel pipelines and pipeline coatings.

The manual gives advice on the....

The Elcometer 133 Shipâ € ™ s Propeller Comparators have been developed with the specific profiles relating to the condition of a shipâ € ™ s propeller.

Two versions are available: ....

The Elcometer 129 Surface Comparators are available in two models:

Elcometer 129 Rubert - available in grit and shot versions.
Elcometer 129 Rugotest - shot and grit profiles....

The Elcometer 127 range of Surface Comparators are available in sand, shot or grit surface profiles.

Each comparator is supplied with 5 profile grades ranging from 0.5 - 5....