Katalog Produk

Keterangan

MIC 10 DL UNIVERSAL HARDNESS MICRODUR TESTER , KRAUTKRAMMER - MULTRON INDOTECH

Method of measurement:
Vickers penetration with indentation eva-
luation by the UCI method under load ( dia-
mond angle 136° )
UCI probes:
To be selected according to application:
Handheld probes:
10 N ( 1 kgf) standard MIC 201-A
short MIC 201-AS
extended MIC 201-AL
50 N ( 5 kgf) standard MIC 205-A
short MIC 205-AS
extended MIC 205-AL
98 N ( 10 kgf) standard MIC 2010-A
Motor probes:
8.6 N ( 0.9 kgf) MIC 211
3 N ( 0.3 kgf) MIC 2103-A
1 N ( 0.1 kgf) MIC 2101-A
Range:
20 - 1740 HV
Conversion:
HV, HB, HRC, HRB
N/ mm² ( only with the 10 kgf handheld probe)
according to DIN 50150, ASTM E 140
Display:
4 digit LCD with switchable backlight
Weight:
approx. 300g
Dimensions:
160 x 70 x 45 mm,
6.3 x 2.8 x 1.8 inches ( W x H x D)
Permissible ambient temperature:
In operation: -15° C to 55° C( 5° F to 131° F)
In storage: -20° C to 60° C ( -4° F to 140° F)
Power:
2 x 1.5V AA batteries
Operational duration:
approx. 15 hours without backlight
Interface ( for version MIC 10 DL) :
RS232C bidirectional
Data Logger ( for version MIC 10 DL) :
Internal memory for up to 1800 measurments,
memory card for up to 590 measurements.
Dependent on the number of measurements
per set. Warning given with memory over ow.
Statistics:
Display of the average value.
For version MIC 10 DL: printout with
maximum, minimum, average value, absolu-
te and relative range, absolute and relative
standard deviation.
Probe accessories:
Handheld probe or motorized probe ( is selected
according to application) ,
Guiding devices and test supports,
TGDL/ PC-data cable ( version MIC 10 DL)
Application software
Further information about our extensive probe and
accessory program will be given on request.

As with all other hardness testers from
our MICRODUR line, the MIC 10
operates according to the UCI method
( Ultrasonic Contact Impedance) .
This method enables quick and easy
measurement: position probe and read
off the value. This operational ease is
achieved because the Vickers diamond
indent in the material’ s surface is
electronically measured and instantly
displayed as a hardness value without
using the cumbersome optical evaluation
of a microscope normally associated with
Vickers hardness testing.
The small, handy MIC 10 makes life
easy for you: a hardness tester that you
can take anywhere - on scaffolds for
testing large containers and pipes, or for
testing components at any location. The
small narrow probes even enable you to
make measurements on positions
dif
cult to access, such as tooth  anks
or roots of gears.
You can measure in any direction, e.g. in
the horizontal or overhead positions.
The instrument carrier and prop-up
stand permits two hand operation, for
correct probe positioning and guidance.