Selamat Datang di
CV.JAVA TECH-SEAL
Anggota Gratis
CV.JAVA TECH-SEAL
Indonesia
Tape Wrap for Leak Pipe
-
- GOT A LEAK?
reduce downtime with
4” x 180”
wraps pipes up to 5” dia
2” x 60”
wraps pipes up to 1.5” dia
see over for full information
Use to repair/ reinforce pipes, T-joints, elbows, valves, cables etc.
PERMANENTLY REPAIRS ALMOST ANY MATERIAL!
Pow-R Wrap is an innovative product that can be applied to high as well as non-pressure applications
and permanently repairs almost any material including copper, steel, galvanised pipe, all plastic pipes,
rubber and cement. It is a water activated fiberglass tape that sets like steel!
APPLY EPOXY PUTTY
IMMERSEWRAP INWATER
WRAP AROUND PIPE
TIGHTEN FOR APPROX 4 MINS
Each complete
Pre-Mixed, Pre-Measured,
Ready-to-use kit contains:
• Resin-impregnated
fiberglass tape in foil bag
• Epoxy putty repair patch
• 1 pair protective gloves
• Full instructions
The benefits of Pow-R Wrap are:
• It’ s quick and easy so reduces downtime
• It lasts for years
• It’ s very safe and conforms to a variety of international standards
All you need is:
• A bucket of water
• A Pow-R Wrap kit
• 30 minutes
No messy mixing or tools required - easy to use kit
• Permanently repairs leaks - even under water!
• Repairs leaks in 30 minutes - sets like steel
• Withstands pressures of up to 600psi
• Heat resistant to 600° C
• Non-toxic - meets EPA601 regulations
• Resistant to a wide range of chemicals
• Works on wet, dry, clean, dirty or corroded pipes
Pow-r Wrap is ideal for all fluid
bearing pipes and hoses:
• Water • Steam • Air • Gas
• Sewage • Fuel • Hydraulics
and is recommended for
structural repairs to:
• Brackets • Fencing • Supports
• Exhausts & Mufflers • Tools
Technical Information
Form Impregnated Fiberglass Cloth
Colour Grey
Fabrication Method Wet Lay-up
Number of Wraps Required 8 ( min) for High Pressure
Cure cycle @ 70° F/ 21° C 30 minutes ( wet)
Hardness - cured laminate 53 Barcol
Heat resistance 1197° F/ 647° C
Dielectric strength 16.969
Line pressures 600 PSI/ 40 KPA
Shelf life Unlimited when properly stored
Mechanical Resistance
MEASURE Method PSI KPA
Flexural Strength ASDN D 709-71 16100 1073
Tensile Strength ASTM D 638 24000 1660
Compression Strength ASTM D 695-77 26600 1773
Temperature cycle test 4 layers cycled from 50° F to 90° F
( 10° C to 33° C) : No delamination.
Approved to EPA601 and AS4020*
Tested and approved for use with potable
( drinking) water when used in accordance
with instructions.
Toxicity
Contains no harmful solvents. Can be used
on water and food service lines.
Chemical Resistance
POW-R WRAP is chemically resistant to diesel
fuel, petroleum products, halocarbons, and
( after curing) alcohols.
* and other international standards
